Sealand Standpipe Kit Manual do Utilizador descarregar pdf (Página 3)

Dometic Standpipe Kit Assembly

3 Assembly

Note

Cement product absorbs moisture. Put lid on container when not is use to keep out humidity.

Note

Curing cement for 24 hours before performing pressure test is strongly recommended.

Caution!

Follow instructions on pipe cement container before use. This is a strong solvent. Wear gloves.

Avoid contact with skin. If cement contacts skin, wash with water while cement is still wet.

1. Arrange ttings and PVC pipe as needed.

2. Cut PVC pipe to length so that ends are square. Remove any burrs with sandpaper (supplied).

3. Clean pipe and tting with dry paper towel or cloth. Remove all dirt, grease, oil and water.

4. Check for proper t before applying cement. Pipe should snugly t 1/3 to 2/3 of the way into the

tting. Sand pipe if needed.

5. Use applicator to spread a thin, uniform coat of cement around outside end of pipe to depth of tting.

6. Apply thin, uniform coat of cement to inside of tting. Prevent excess cement from forming on inside

of pipe or outside of tting.

7. Insert pipe to bottom of inside of tting, using a 1/4-twist while inserting. Hold in place for one minute.

8. Remove excess cement from outside and inside of pipe with dry paper towel. Excess cement will

continue to drip from pipe and tting and may remain liquid if not completely removed.

9. Allow ve minutes for good handling strength and one hour cure time before pressure testing. High

humidity or cold weather requires longer cure time. Cement cures to full strength in 24-72 hours.

10. After curing, run water through nished assembly to ush out and neutralize any cement inside pipe.

1 2 3 4 5 6 7 8 ... 23 24

Sem comentários

Sealand Standpipe Kit Manual do Utilizador Página 3